Showing 1–12 of 160 results

QMC Starter Kit

Make your first steps with the new VITA 93 - QMC mezzanine standard
- Quad UART QMC
  - Single size QMC Module
  - Multiprotocol transceiver offering RS232/RS422/RS485
  - Operating temperature -40 °C to +85 °C
  - Air-Cooled
- Dual QMC Carrier
  - Low-Profile PCIe Card
  - 2 QMC sites
  - VHDCI68 Front I/O Connector
  - Operating temperature -40 °C to +85 °C
- Cable Kit
  - 1.8 m cable with VHD68 SCSI-V male and HD68 SCSI-3 male type connector
  - 68 pin terminal block
- Device Driver
VIEW FULL SPECIFICATIONS
TCPS210

CompactPCI Serial Carrier with 3 QMC Sites, PCIe Gen3 x4, Rear-I/O
- CompactPCI Serial compatible 3U module (PICMG CPCI-S.0 R3.0)
- Cost-effective solution to provide I/O in CompactPCI-Serial environment
- Flexible I/O (TEWS offers a wide range of QMCs)
- 3 single-width QMC Sites, compatible with double- and triple-width QMCs
- Full QMC I/O on P2, P3 an P4 rear I/O
- PCIe Gen3 x4 from host to QMCs
- Management controller for surveillance of QMC health status
VIEW FULL SPECIFICATIONS
TPCE210

PCI Express x4, Gen 2, Dual QMC Carrier
- Low-profile PCI Express Revision 2.0 compatible module
- Cost effective solution to provide I/O in PCI Express environment
- Flexible I/O (TEWS offers a wide range of QMCs)
- Supports two single QMCs or one double QMC
- Provides QMC front panel I/O via VHDCI-68 Connector
- Management Controller for surveillance of QMC health status
VIEW FULL SPECIFICATIONS
TPCE646

Reconfigurable MPSoC with 32 x 16 bit Analog Output and 8 x 16 bit differential Analog Input
- Form Factor: X8 PCIe
  - Board size: tbd. x 98 mm
- PCI Express x8 Gen 3 Link from PCIe Card edge conector to MPSoC PL.
- Optional PCI Express x4 Gen2 Link to MPSoC PS.
- TPCE646 MPSoC options:
- -10R Xilinx XCZU11EG-1FFVC1760I
- Serial Flash for MPSoC Configuration
- FPGA clock options:
  - Local clock generator as source for the MPSoC internal PLL
- DDR4 SDRAM PL bank, 64 bit 1GB
  - (up to 8 GB)
- DDR4 SDRAM PS bank, 64 Bit 4GB
  - (up to 8 GB)
- 8 MPSoC PS Multi-Gigabit-Transceiver on a seperate Samtec FireFly© connector.
- Front I/O lines
  - 8 differential analog inputs
    - 16 bit resolution
    - 5 Msps
    - Factory calibration
  - 32 differential analog outputs
    - 16 bit resolution
    - ±10 V single ended output
    - Factory calibration
    - 4 differential digital LVDS I/O lines
- Rear I/O lines
  - 64 single ended or 32 differential rear I/O lines on a rear 68 pin Samtec QTE© connector.
  - 8 MPSoC PS Multi-Gigabit-Transceiver on two seperate rear Samtec FireFly© connector.
  - 10/100/1000 Mbps RJ45 Ethernet Interface
VIEW FULL SPECIFICATIONS
TQMC400

4 Channel Full-Modem RS232/RS422/RS485 Programmable Serial Interface
- Standard single QMC module conforming to VITA 93.0
- 4 UART channels with programmable RS232 / RS422 / RS485 interfaces
- High performance asynchronous serial interface (up to 20 Mbps)
- Software selectable 120 Ω Termination for each RS422/RS485 channel
- Hardware handshake support available
- Half-duplex mode available
- 256 byte FIFO
VIEW FULL SPECIFICATIONS
TQMC401

4 Channel High Speed Sync/Async Serial Interface
- Standard single QMC module conforming to VITA 93.0
- 4 channels high speed serial data communication
- Several communication protocols
- asynchronous (with oversampling)
- isochronous
- HDLC
- 512 longword FIFO (512 x 32 bit) per channel
- DMA support
- Different signal encodings (NRZ, NRZI, FM0, FM1 and Manchester)
- Multiple clock sources (for a wide bitrate spectrum)
VIEW FULL SPECIFICATIONS
TQMC402

4 Channel Isolated RS232/RS422/RS485 Programmable Serial Interface
- Standard single-width QMC module conforming to VITA 93.0
- 4 UART channels with programmable interfaces
  - RS232
  - RS422
  - RS485 (full- and half-duplex)
- Channels are isolated from system and against each other
- High performance asynchronous serial interface (up to 20 Mbps)
- Software selectable 120Ω termination
- 256 byte FIFO
VIEW FULL SPECIFICATIONS
TQMC500

20 Isolated Analog Inputs, Simultaneous Sampling
- Standard single-width QMC module conforming to VITA 93.0
- 20 channels isolated analog input
- 16 bit resolution
- Simultaneous sampling
- Sampling rate: 800 kSPS
- Differential and single-ended input signals supported
- Programmable input voltage range
VIEW FULL SPECIFICATIONS
TQMC600

Reconfigurable FPGA with Digital I/O
- Standard single-width QMC module conforming to VITA 93.0
- User programmable FPGA
- 32 TTL lines, 5 V tolerant or 16 differential I/O lines (EIA-422 / EIA-485 compatible) or 16 differential Multipoint-LVDS lines
- ESD protected I/O lines
- Each I/O line is individually configurable (e.g. direction)
- 3 state TTL output (high, low, and tristate)
- Onboard termination for differential I/O lines
VIEW FULL SPECIFICATIONS
TQMC601

32 Isolated Digital Inputs (15-60 V)
- Standard single-width QMC module conforming to VITA 93.0
- 32 interrupt generating digital inputs
- Galvanic isolation of inputs to system
- IEC 61131-2 Type 3 input-characteristic
- 60 V maximum input voltage
VIEW FULL SPECIFICATIONS
TQMC602

16 Digital In, 16 Digital Out (0.3 A), Isolated
- Standard single-width QMC module conforming to VITA 93.0
- 16 interrupt generating digital inputs
  - IEC 61131-2 Type 3 input-characteristic
  - 60 V maximum input voltage
- 16 digital outputs
  - Up to 4 us update rate
  - High- or low-side switching
  - 0.3 A per output
  - 36 V maximum supply voltage
  - Outputs withstand up to 65 V
- Galvanic isolation of inputs and outputs
VIEW FULL SPECIFICATIONS
TQMC603

20 Digital Outputs (5-36 V, 0.3 A), Isolated
- Standard single-width QMC module conforming to VITA 93.0
- 20 digital outputs
- Up to 4 us update rate
- High-side, low-side, push-pull switching
- 0.3 A per output
- 36 V maximum supply voltage
- Outputs withstand up to 65 V
- Galvanic isolation
VIEW FULL SPECIFICATIONS

QMC Starter Kit

TCPS210

TPCE210

TPCE646

TQMC400

TQMC401

TQMC402

TQMC500

TQMC600

TQMC601

TQMC602

TQMC603