Showing 61–72 of 269 results
-
TPMC895
4 Channel 1000BASE-T Ethernet
- Standard single-width 64 bit PMC module
- 4 channel 1000BASE-T / 100BASE-TX / 10BASE-T
- PXE and iSCSI boot (16 Mbit serial flash)
- Capable to perform auto negotiation algorithm for best link parameters
- IEEE 1588/802.1AS Precision Time Protocol (PTP) and IEEE 802.1Qav Audio/Video Bridging (AVB) traffic shaping
- Front I/O via RJ45 and/or P14 I/O
-
TPMC821
Interbus Master Interface Generation 4
- Standard single-width 32 bit PMC module
- INTERBUS Master Generation 4 (G4) Interface
- Uses original INTERBUS Master Generation 4 (G4) firmware from Phoenix Contact
- Optically isolated INTERBUS interface
- RS232 diagnostic port
- Status LEDs
-
TPMC866
8 Channel Serial Interface RS232 / RS422
- Standard single-width 32 bit PMC module
- 8 channels RS232 and/or RS422 interfaces
- Asynchronous serial interface (up to 460.8 Kbps)
- Hardware handshake and full modem support available
- 64 byte FIFO
- Front panel I/O (HD50 SCSI-2 type connector) and P14 I/O
-
TPMC866-IO
DIN Rail Mounting I/O Module (8 x DB9) for TPMC866
- DIN Rail Mounting I/O module
- Distributes 8 serial channels
- from 50 pin ribbon cable connector
- to 8 DB9 male connectors
- Compatible with TPMC866
-
TPMC866-TM
Transition Module for TPMC866
- U6 8TE front panel transition module
- Distributes serial channels
- from 50 pin ribbon cable connectors
- to DB25, RJ45 or RJH connectors
- Compatible with TPMC866
- Multiple configurable interfaces
-
TMPE623
Reconfigurable FPGA with Digital I/O PCIe Mini Card
- Standard PCI Express Mini Card
- User programmable FPGA (AMD Artix™ 7)
- 26 TTL lines (5 V-tolerant) or 13 differential I/O lines (EIA-422 / EIA-485 compatible) or 13 differential Multipoint-LVDS lines
- ESD-protected I/O lines
- Each I/O line is individually configurable (e.g. direction)
- 3 state TTL output (high, low, and tristate)
- 3 TTL pull voltages (GND, 3.3 V, and 5 V)
- Onboard termination for differential I/O lines
- Provides a basic heatsink to facilitate thermal management
-
TMPE627
Reconfigurable FPGA with AD/DA & Digital I/O PCIe Mini Card
- Standard PCI Express Mini Card
- User programmable FPGA (AMD Artix ™ 7)
- 14 TTL lines
- 5 V-tolerant
- ESD-protected I/O lines
- Each I/O line is individually configurable (e.g. direction)
- 3 output state (high, low, and tristate)
- 3 pull voltages (GND, 3.3 V, and 5 V)
- 4 channels 16 bit ADC
- Offering single-ended and differential mode
- 7 individually selectable voltage input ranges (up to ±10.24 V)
- Sampling rate up to 200 ksps
- 4 channels 16 bit DAC
- 4 individually selectable voltage output ranges (up to ±10.8 V)
- 10 μs conversion time
- Factory calibration data for ADC and DAC is available
- Provides a basic heatsink to facilitate thermal management
-
TMPE863
3 Channel High Speed Sync/Async Serial Interface
- Standard PCI Express Mini Card
- 3 channels high speed serial data communication
- Differential I/O lines for EIA-422, EIA-485 Full-Duplex
- Several communication protocols
- asynchronous (with oversampling)
- isochronous
- HDLC
- 512 longword FIFO (512 x 32 bit) per channel
- DMA support
- Different signal encodings (NRZ, NRZI, FM0, FM1 and Manchester)
- Multiple clock sources (for a wide bitrate spectrum)
- 30 pin Pico-Clasp latching connector
- Provides a basic heatsink to facilitate thermal management
-
TMPE633
Reconfigurable FPGA with Digital I/O PCIe Mini Card
- Standard PCI Express Mini Card
- User programmable FPGA (AMD Spartan ™ 6)
- 26 TTL lines (5 V-tolerant) or 13 differential I/O lines (EIA-422 / EIA-485 compatible) or 13 differential Multipoint-LVDS lines
- ESD-protected I/O lines
- Each I/O line is individually configurable (e.g. direction)
- 3 state TTL output (high, low, and tristate)
- 3 TTL pull voltages (GND, 3.3 V, and 5 V)
- Onboard termination for differential I/O lines
-
TPCE260
PCI Express PMC Carrier
- Standard height PCI Express Revision 1.1 compatible module
- Cost effective solution to provide I/O in PCIexpress environment
- Flexible I/O (TEWS offers a wide range of I/O PMCs)
- PCIexpress x1 link
- Supports one single-width 32 bit PMC
- 33 MHz / 66 MHz PCI frequency (PMC site)
- Provides access to the PMC front
- Provides rear I/O (P14) through a VME P2 style connector
-
TPCE261
PCI Express x1 PMC Carrier
$1.00- Standard height PCI Express Revision 2.0 compatible module
- Cost effective solution to provide I/O in PCIexpress environment
- Flexible I/O (TEWS offers a wide range of I/O PMCs)
- PCIexpress x1 link with 2.5 GT/s
- Supports one single-width 32 bit PMC
- 33 MHz / 66 MHz PCI frequency (PMC site)
- Provides access to the PMC front panel I/O
- Provides rear I/O (P14) through a 68 pin ERNI SMC 1.27 mm flat cable connector
-
TPCE275
PCI Express x1, Gen 1 XMC Carrier
- Standard height PCI Express Revision 1.1 compatible module
- Cost effective solution to provide I/O in PCI Express environment
- Flexible I/O (TEWS offers a wide range of I/O XMCs)
- Supports 1 single-width XMC
- Provides front panel I/O
- Provides XMC P14 rear I/O through VME P2 connector
- Provides XMC P16 rear I/O through two 50-pin flat cable connectors
- PCI Express x1 from host board to XMC
- PCIe Redriver allows safe operation of XMC module in distributed PCIe systems